Q Acoustics QI80C Professional In-Ceiling Speaker (Each)
or 4 fortnightly payments of $99.75 with More info
Q Acoustics QI80C In-Ceiling Speakers (Each)
Online & Store
The Qi80C is the most powerful of the Professional in-ceiling range from Q Acoustics including the beautiful Q Install magnetic grille design where the super slim bezel and narrow-mesh grille clips firmly into place. The major benefit of this grille design is that it makes a larger diameter in-ceiling speaker look much less obtrusive. As with all our Install products they feature protective driver dust covers and cloth backed grilles to facilitate painting. The Q Acoustics Qi80c Inceiling Speaker delivers more punch and hifi quality sound, so if its music and detail in surround sound in Dolby Atmos, DTS-X then these are the best in-ceiling effect speakers.
- Bezel and grille design that clips magnetically into place, with the grille geometry being carefully optimised to ensure the perfect balance between sound and discrete appearance
- The HF is adjustable by + or – 3dB from a switch on the crossover
- Circular and square grille options are available to ensure the perfect match for each customer’s decor.
- Less than 87 mm deep.
- ‘UL94’ flame retardant materials
- Moisture proof
- Q Install speakers come carefully packaged with installation template and fitting instructions
Easy to install
- A cutter guide is supplied to mark out the hole you need to make
- The speakers attach to your ceiling via four clamps you screw from the front
- Speaker terminals have push open connectors that you can do with one hand
- The grilles attach via magnets
|Tweeter diameter:||0.75″ (19mm)|
|Power handling (program):||15-60W|
|Impedance (nominal) ohms:||8 ohm|
|Sensitivity dB spl (2.83V, 1m):||88|
|Response(Low freq.) -3dB Hz:||63|
|Maximum rear depth:||87mm|
|Size(Round grilles):||281mm dia|
Select a suitable mounting location for the speaker taking note of the Warning Notices above. Using the installation template supplied mark the speaker position and cut the mounting hole.
Make sure all equipment is switched off. The speaker cable should be stripped back ~10mm so that there are bare wire ends. Remove the packaging and protective dust cover from speaker and attach the speaker leads using the pushdown spring clip terminals at the rear of the speaker. The positive conductor should be connected to the red terminal and the negative conductor to the black terminal. Note: Tweeter output level adjustment (‘P’ & ‘CW’ versions) It is recommended to leave the switch in the ‘0’ position for the initial sound check.
Check that each of the 4 swing out clamps are rotated inwards. Push the speaker through the mounting hole and position flush with the ceiling. Whilst holding the speaker in place tighten each of the mounting screws using a No. 2 Pozidriv® screw driver in the order shown in the diagram (left). When an increase in resistance is felt the clamp is in position.
Once the speakers are installed they should be tested before the grilles are fitted. The 6.5” Performance in-ceiling stereo speaker feature a swivel tweeter that may be adjusted allowing the high frequencies to be directed towards or away from the normal listening position as required. The tweeter’s outer frame (not dome) should be pushed gently to achieve the desired tweeter position.
The 6.5” Performance in-ceiling stereo speaker features a magnetic grille, locate the grille over the speaker bezel where it will be pulled into place. Note that square grilles may be positioned at any angle required. Some models feature a white backing cloth behind the grille to help minimize visual contrast with the ceiling. For the very best sound performance it is recommended that this cloth is removed before use. To remove simply peel away the backing cloth from the grille.
(Low freq.) -3dB Hz: 63
Q Acoustics QI80C In-Ceiling
In-Wall or In-Ceiling Speaker